Turning the eggs keeps the developing chick embryo centered within the egg, minimizing the risk of sticking to the cell membrane, which may lead to a failed hatch. A broody hen will naturally move the eggs around about every 15 minutes, either by adjusting herself in the nest or by reaching down with her beak, rolling them manually. Post hatch: When chicks are removed from the incubator, they must have a place that is warm and dry.Egg turning during the incubation process is a critical part of successful hatching.This allows the chick to rotate freely while breaking the shell during hatching. Hatching eggs: When you have 3 days remaining until hatch, remove the second red vent plug from the top of the incubator to increase ventilation.Light will pass through the hole, into the egg, so that it is illuminated. Now place a strong light source (e.g., flashlight) under the box or can. Make a hole with a diameter of about 25% the size of the egg (about the size of a quarter) in the top of the box or can. A candler can be can be made using a shoe box or can. Test egg fertility: Testing is done by candling all eggs in the incubator.Refer to the manual for specific instructions. Turning the eggs: Depending on what type of egg turner is being used.Mark and set the eggs: The turner on this incubator is built for small to medium eggs, do not put turkey or other large eggs in it.Eggs should be held in a cool location between 50 degrees Fahrenheit - 55 degrees Fahrenheit until you are ready to incubate. Avoid breathing on eggs, particularly if you have a cold or are ill. Maintain sanitary conditions: Always wash hands with soap before before handling eggs.Use numbers on side of incubator to identify each of the six water channel locations. Lift the lid and slide it far enough to allow a baster to fit between the lid and base. Humidity control and ventilation: Use a turkey baster to add water.Press and release the SET button to display the current temperature or wait ten seconds and the current temperature will display automatically. The temperature controller should come on with the humidity and current temperature displayed as soon as it is plugged in.Press and release the SET button to display the setting temperature. The incubator is pre-set to 99.5 degrees Fahrenheit.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |